Charger power test system Economic intelligent power test system Power test system manufacturers
LED Power Supply Automatic Testing System Features:
Open
• Open hardware platform, allowing for the addition or removal of various testing devices as per customer requirements (including devices with GPIB, RS-232, USB interfaces)
• Supports simultaneous testing of multiple single/multiple group output LED power supplies, significantly enhancing production line capacity
• Open software platform, allowing for the expansion of various new testing items and functions based on customer testing requirements
• Supports multi-lane barcode pre-scanning function, and supports barcode scanning during testing to improve overall testing speed
Universal
• Supports testing of various power supplies (LED power supplies, adapters/chargers, PC power supplies, inverters, communication power supplies, etc.)
• Complies with Energy Star (ENERGY STAR) and IEC 62301 measurement requirements
• Supports Manufacturing Information System (ShopFloor) interface
• Supports testing of various power supply parameters under CV.CC.CR.LED modes
• Optimized display mode, arbitrarily combined hardware configuration
Professional
• Supports complete testing of LED driver power supplies
• Can accurately read the average current and effective current of the tested LED driver
• Can easily start low-power LED driver power supplies without pulling down the LED driver due to the large current surge from starting the electronic load
• By setting realistic LED turn-on threshold values and post-turn-on operating point resistance through the system, the test current and voltage waveforms are very close to real LEDs
• More realistic high-frequency current waveforms
• Dimming function testing: dimming current, dimming frequency, dimming cycle (requires additional related hardware devices) The LED Power
Test Items for the Switching Power Supply Testing System :
| Test items | Test items |
| Measuring under LED.Mode | Tracking |
| DC Current under C.V.Mode | Short circuit test |
| Peak-Peak noise | Short circuit current |
| Current peak-Peak noise | OV protection |
| Voltage peak-Peak noise | UV protection |
| Transient response time | OL protection |
| Transient spike | OP protection |
| Voltage regulation | In-test adjustment |
| Current regulation | AC cycle drop out |
| Turn ON time | PLD simulation |
| Rise time | GPIB read/write |
| Fall time | 232 read/write |
| Hold-up time | USB read/write |
| Inrush current test | TTL signal control |
| Power good signal | Relay control |
| Power fail signal | Bar code scan |
| P/S ON signal | Dynamic test |
| Power up sequence | Specification under C.P.Mode |
| Power off sequence | DC output current |
| Effciency | DC output voltage |
| Input RMS current | Current Ripple test |
| Input power | Dimming Current |
| Input power factor | Dimming frequency |
| Input voltage ramp | Dimming period |
| Input freq. ramp | |
